We undertake a wide range of residential, commercial and infrastructure construction works, covering various construction scenarios including swimming pools, factories, railway facilities, docks, chimneys and large-scale transportation infrastructure.
2013
The pier and roof structure were cut into segments, with the largest segment weighing about 300 tons, then transported for reassembly.
View Case →
2013
High-level chimney sections were cut and removed by wire saw cutting; segment weights ranged from about 30 to 100 tons.
View Case →
2013
A 150m-high chimney was demolished in controlled sections for lifting and removal.
View Case →
2013
About 120 holes, 650mm in diameter and 4m deep, were cored with multiple hydraulic coring machines.
View Case →
2013
A 30m-long eave was divided into 12 pieces for controlled lifting and removal.
View Case →
2013
Low-noise hydraulic splitting was used for slab demolition to reduce disturbance.
View Case →
2013
The existing wall was divided into manageable sections and stored on the same floor for clearance.
View Case →
2013
Low-noise hydraulic crushing was used to demolish the slab in an urban environment.
View Case →
2013
Brokk 40 and 50 remote robots with hydraulic crushing were used to demolish the canopy.
View Case →
2013
Retaining walls were cut and removed, with robots and hydraulic breakers used for basement works.
View Case →
2013
Floor, wall and basement concrete structures were cut in a confined station environment and removed in sections at night.
View Case →
2013
The stairway was divided into three pieces and the pathway into seven pieces, then lifted and transported away.
View Case →
2013
Fifty-four reinforced-concrete pile heads were demolished about 10m below water level and lifted out in sections.
View Case →
2013
Two large retaining walls were cut into sections and removed by heavy cranes.
View Case →
2013
A reinforced-concrete foundation was divided into sections for lifting and clearance.
View Case →
2013
The slab was divided into sections using a three-phase blade saw cutting machine.
View Case →
2013
The observation deck was divided into sections of different sizes for lifting and removal.
View Case →
2013
A large tunnel retaining wall was demolished with remote equipment in a confined work area.
View Case →
2013
The 410.44m bridge demolition and reconstruction was carried out in two phases.
View Case →
2013
The four-storey concert hall, built in 1930, was relocated about 66.4m using low-vibration, low-noise cutting.
View Case →
2013
Large concrete plinths up to about 7m thick were dismantled in sections weighing roughly 20 to 30 tons.
View Case →
2013
Uneven bridge piles were cut to a consistent level while minimizing impact on the structure.
View Case →
2013
Concrete structures at the main building and vehicle lanes were demolished, involving about 1,900m³.
View Case →
2013
About 4,000m³ of walls and slabs were demolished with multiple robots in a confined site.
View Case →